Knowledge Base

Stretching limit

The stretching limit is a characteristic material parameter which can be determined in a tensile test. It is the stress defined as the internal force of resistance per unit of area perpendicular to the direction of load application with which a material reacts to an external tensile load of specific magnitude. At the stretching limit the deformation of the workpiece or the elongation of the tensile specimen due to the external tensile load continues to increase although the inner resistance remains constant or even decreases.

For process materials in the wire industry, where the materials used are preferable drawn wires, it is typical for the resistance to the load not to decrease at the stretching limit. Hence the stretching limit cannot be identified in the stress/strain diagram. DIN EN 10 002, the tensile test guideline for metallic materials, thus recommends determining an elongation limit at a non-proportional strain. Accordingly it is no longer the stretching limit, which is determined for drawn materials in the wire industry, but the elongation limit at a non-proportional strain of 0.2%. This is also referred to as the technical elongation limit.

The stretching limit or elongation limit at a non-proportional strain is a value used in the simulation of the WITELS-ALBERT wire straightening process for calculating the adjustments required to achieve a defined final curvature.

Swelling

The loading of a body by mechanical variables (forces, moments) produces stresses in the body, causing the body to deform in accordance with its material characteristics. The magnitude of the load decides whether this deformation takes place in the elastic or plastic zone.

Swelling is understood to be an elastic deformation which is reverted when the external load is removed. It consists of strains, compressions and bends. Every straightener and every straightening machine swells under the action of the straightening forces. It is a characteristic of straighteners, therefore, that the adjustment of their straightening rolls becomes smaller and the straightening gap larger, leading to changing results.

Each straightener has its own force/swelling characteristic, meaning its own specific deformation behavior. This characteristic has to be determined for the straightener in question if constant straightening results are to be achieved regardless of swelling.