Knowledge Base

Curvature

Curvature is understood to be a deviation from the straight.

When an endless material is wound onto a spool, the inner layers have a smaller radius of curvature and the outer layers a larger radius of curvature.

Whether or not a winding is elastic or plastic depends on the spool geometry, the properties of the endless material, and the degree of deformation.

Curvature is the reciprocal of the radius of curvature and has the dimension [1/mm].

Curvature course during straightening

The curvature course during straightening is understood to be the correct sequence of curvatures followed by the process material during the straightening process.

The initial curvature is always followed by the counter-curvature. The final curvature is the curvature remaining after spring back. This curvature sequence is repeated according to the number of straightening rolls.

A straightening process should be arranged so that, irrespective of the initial curvature, the last adjustment-induced curvature resulting after the last spring back in a final curvature corresponds to the desired straightening result.