Knowledge Base

Semi-automatic straightening

Semi-automatic straightening is straightening with the use of offline and online data, basic automation equipment and at least one straightener. The offline and online data is relayed via the basic automation equipment to the straightener in order to achieve a defined and highly exact adjustment of the straightening rolls. A semi-automatic straightening system enables the reproducible adjustment of roller positions at any time.

The advantages of a semi-automatic straightener over a straightener with conventional roll adjustment are:

  • defined fine adjustment of the individual straightening rolls,
  • reproducibility of straightening roller positions within close tolerances,
  • application of high adjustment forces,
  • operation of the roll adjustment system from any location,
  • use of process data (data bases),
  • integration in a central control environment.

Simulation

Simulation is the representation of specific interesting properties of a system by the actions of a different system. By copying the behavior of a system in a simulation program it is possible to study behavioral characteristics or to examine variants. Simulation can be used at low cost and with little risk to identify behavioral patterns in time-consuming, costly, uncertain and hazardous processes.

With a simulation of the wire straightening process it is possible to pre-calculate the positions of the straightening rolls needed to prcduce a defined final curvature while taking due account of the parameters of the straightener (number of rolls, external roll diameter, roll pitch, groove width, groove angle) and of the wire (cross sectional geometry, elongation limit, modulus of elasticity, modulus of hardening, initial curvature, etc.). The simulation is based on a model of the elastic-plastic material characteristic under alternate bending and on the relationship between bending moment and curvature. Simulation of the wire straightening process also supplies data which can be used to determine the process forces.

Speed

In the forming processes employed in the wire producing and wire processing industry it is normal for the process material or workpiece to move relative to the tooling. Forming speed is one of the variables which characterize a forming process. It is derived from the degree of forming as a function of time.

Exemplary straightening tests conducted at different speeds of the process have proven that the final curvature and other parameters of the straightening process do not change significantly in the speed range up to approximately 10 m/s. At speeds above this limit, an identical adjustment of the straightening rolls results in a different deformation.

Spool

Spools are used for the safe transportation of endless material. The material is wound onto the spool layer by layer so that it is difficult for individual windings to slip. Spools have a minimal (inner) and a maximal (outer) diameter. This has two important consequences: a difference in speed and a difference in curvatures.

Status quo

Latin for "the existing state".
To be able to design a straightening process in a defined manner it is first vital to identify the status quo as the starting point for producing the necessary change of state with the bending operations and tools available. For a reproducible straightening process it is essential, for example, to document the positions of the system's straightening rolls relative to the process material. This data can then be used at any time to produce specific straightening results under identical framework conditions.

Straightened material

Straightened material is a workpiece whose properties have been changed by the straightening process. Its most important property is straightness or final curvature. Other properties, apart from straightness, changed by the straightening process include the material's internal stress condition.

A straightened material can be endless or finite. Rails and sheets are examples of finite straightened material. Wire, cable and rope are endless straightened material.