Knowledge Base

Tensile test

The tensile test according to DIN EN 10 002 is a static test method. It is the most important test for determining a material's mechanical parameters. A standardized test bar is subjected to an increasing tensile load in its axial direction. The test-piece, which is clamped at both ends in suitable clamping fixtures, has a specific test length which is bigger than its measured length.

The test is performed on a testing machine, often continuing until the test-piece fails. Tensile force and the change of length are recorded and plotted in a diagram. This is followed by presentation in a stress/strain diagram using the initial values for the material cross section and the test length. From the stress/strain diagram it is possible to derive parameters which express the material's behavior under external loads. The parameters most often determined are:

  • modulus of elasticity
  • stretching limit
  • tensile strength
  • elongation to fracture

Unspooling/unwinding

Basically the methods used to unspool or unwind a material which is to be straightened break down into two categories: static or dynamic.

With the static method the spool or reel is not moved. Material is paid off in axial direction so that a helix or twist is created in each winding as it is removed, with negative consequences for the follow-up process.

With the dynamic method of pay-off the spool or reel is rotated around its axis, which may be arranged vertically or horizontally, enabling the material to be paid off without suffering any torsion.

Windings are at risk of slipping only in vertical unspooling or unreeling set-ups, particularly in intermittent processes. A horizontal pay-off may be more elaborate technically, but it is the better solution with a view to follow-up processing operations.

Zero line

The term “zero line” is used in two contexts. The first is the zero line of the processing system and the second is the zero line in the straightener.

The term zero line of the processing system is understood to mean that the product to be straightened runs through the processing system without undergoing any additional bending, deflecting or guiding. It is an advantage therefore for wide spools to be axially adjustable in order to always obtain the required zero line. The zero line of the processing system includes the zero line in the straightener.

The term zero line in the straightener describes the situation when all the straightening rolls touch the product to be straightened but do not bend it. This setting is usually made with a caliber, hence the term calibration. The zero line in a straightener depends on the geometry of the product to be straightened and of the straightening roll groove.